FREE SHIPPING. AMERICAN MADE ONE (1x) 3D AC ENGINE WIRING HARNESS.
Connectors and fuse box are 3D printed with Polyethylene Terephthalate Glycol (PETG) plastic for strong UV resistance. And more material has been added where possible to beef them up compared to original connectors.
Original nylon connectors commonly crumble and fall apart after a season or two of sun exposure. PETG plastic is approximately as strong as nylon brand new, but keeps that strength over time despite frequent sun exposure. This should be the last harness you have to buy for a long while.
The wire used in this harness is American pure copper stranded automotive wire. 16AWG for power, and 20AWG for signals / lower power circuits.
No cheap CCA or aluminum wire.
This harness connects to:
- 6-pole Original Stator (or 8-pole upgraded stator)
- AC-fired CDI
- Ignition Coil
- 4-pin Rectifier
- Starter Solenoid
- Electric Auto-choke
- Chassis Section
- BONUS: Built-in extra ground wire and ring to ensure a strong reliable spark! Bolt the ring to your crankcase under one of the 8mm transmission bolts!
(These separate items aren't included... This harness is sold exactly as pictured.)
This harness is based on the Tomberlin Crossfire 150, 150R and Punisher harness and wiring diagram. Directly connects to these specific models.
Zip-tie mounts are integrated into the fuse box base, so you can easily mount the harness to your tubular frame in an organized way. No rats nest with loose wires packed in everywhere. Internal branch connections are sealed with adhesive-lined ALPO heat shrink. However, try to keep the fusebox in a dry location tucked away from splashes (as much as you can).
Absolutely NO loose vinyl sleeves are used, every connection has a HARD cover that won't ride up and cause shorts. Solves the problem stock harnesses have. Bullet connects use adhesive-lined sealing heat shrink that isn't going anywhere, and transparent so you won't have hidden corrosion issues playing mind games with you down the road.
All connectors are permanently LABELED (3D printed right on top) where they're supposed to go, so you don't have to wonder what connects to what. Super easy.
10A Fuse: Uses a standard 10 amp mini blade fuse (ATM) that you already have a thousand spares.
Stator compatibility: Supports 6 pole and 8 pole stators. 2x35watt headlights can be used on 6-pole systems. 2x45watt headlights can be used on 8-pole systems.
PROUDLY MADE IN AMERICA
We warranty that printed connectors will physically fit their stock counterparts. And that you will get stronger spark than ever, along with proper +12v battery charging, auto-choke, and starter solenoid functionality (assuming you're using a good quality CDI, rectifier, resistor, and switches).
However, this item is sold without implied warranty of merchantability or fitness to be used on a go kart or buggy (beyond physically fitting, and operating the normal functions described above under normal riding conditions). This harness is made using the original wiring diagrams and much better wire, but has not been rated by any third-party testing facilities. As such, this product is sold "as is", with any and all faults. By purchasing, you agree that you are using this product at your own risk. Please keep an eye out for problems during use, and let us know right away if you suspect an issue. We'll use your input to make the product even better.
In the case that your harness is defective (non-functional in some way), cease use immediately and contact us with details. We'll exchange for a replacement.
Be sure to pick up a parts kit! (Sold separately)